Filter
Top Products
Options 2-5
Options
When you press the a (Options) key from the printer control
panel, you can scroll through each of the options by pressing
the up or down arrows.
◆
To select an option, press the
e
(Menu Select) key.
◆
To go back to the previous level, press either the
b
, or the
h
(Cancel) key.
Each of the control panel options is described in the following
paragraphs.
Advance Media
◆
Press the
c
key to advance the paper forward. When you
press and hold the
c
key, the paper moves faster. You can
also press the Media Advance switch on the rear of the
printer, below the left profiler docking station, to advance
the paper.
◆
Press the
b
key to advance the paper back onto the supply
spool. When you press and hold the
b
key, the paper moves
faster.
Maintenance
◆ Prime
- Fires all jets by drawing a set of lines called “prime
bars.” This is a good way to inspect and prepare the jets for
printing after they have been idle for more than a few hours.
◆ Access Print Heads
-
Selecting this option moves the car-
riage out of the service station so you can load one or more
Big Ink packs or clean the print heads. See “Installing Big Ink
Packs” on page 3-6 for instructions.
◆ Access Service Station
- Selecting this option moves the car-
riage out of the service station to a point left of the Access
Print Heads position.
Change Media
Selecting this option causes the printer to measure the width of
the media installed in the printer. This is also done automati-
cally when the printer is powered on and before each print job.
Load Media Sheet
Selecting this option allows you to load a cut sheet of media,
rather than a roll-fed sheet. After selecting this option, stand in
front of the printer, and place the media as instructed by the
control panel. The printer will pull the sheet toward the rear of
the printer, and measure its width and starting position. See
“Loading Media Sheet” on page 3-21 for instructions.