Filter
Top Products
AutoSet Calibration 4-3
5. Press
f
(Proceed).
The AutoSet calibration begins. First, AutoSet tests the jets
on each cartridge for electrical failure.
◆
If any jets with electrical failures are found, the printer
displays a list of the failed jets. Then press
e
(Menu
Select) to run AutoSet.
◆
If too many cartridges are found with an electrical fail-
ure, an accurate AutoSet calibration cannot be per-
formed. Clean the electrical contacts, inspect the flex
cable, and reinstall the cartridge(s) specified on the con-
trol panel, then press
d
(Retry) run the electrical test
again.
6. AutoSet prints a calibration pattern, then looks for missing
and deflected jets on each cartridge.
◆
If a small number jets on any one cartridge are missing
or deflected, AutoSet will compensate for them during
printing.
◆
If too many jets on any one cartridge are missing or
deflected, AutoSet marks the cartridge as out-of-specifi-
cation. It then asks whether you want to view a list of
these cartridges.
7. When AutoSet completes, press the
h
(Cancel) key repeat-
edly until the
Ready to receive
message appears.