Filter
Top Products
3-8 Installing Big Ink Packs
The routing clips allow the tube to lay flat along the track.
Do not leave any slack in the hose along the track, but do
not place any tension on the tube.
Keep the tube in the same position along the entire length
of the track. This will enable you to replace any single Big
Ink pack, without the ink tubes becoming tangled with one
another.
Do not allow the tubes to become crimped.
12. Loosely coil the excess ink tubing and neatly place it on top of
the Big Ink pack.
Keeping the ink tubes neatly organized will make it easier to
replace individual packs.
13. Repeat steps 4 through 12 for each of the remaining Big Ink
packs to be loaded.
14. Open the valves on all of the ink tubes, and ensure that there
are no kinks or obstructions in the tubes. Massage out the
crimp in the tube created by the valve.
15. Return the print head carriage to the service station.
The control panel should display the message “Press proceed
to park heads.” Press the f (Proceed) key. This moves the
print head carraige back to the service station.
16. If necessary, adjust the print head height.
For instructions, see “Adjusting the Print Head Height” on
page 3-16.