Filter
Top Products
Options 2-7
◆ Reset Reg Data
- resets all registration data to their factory
default values.
Customize Settings
This menu consists of two submenus: Settings and Modes.
Settings
◆ Takeup Direction
- (available if takeup motor is installed)
allows you to wind the printed output onto the takeup spool
Image Inside or Image Outside.
◆ Space Between Prints
- allows you to set the amount of
blank space between prints.
◆ Top Gutters
- allows you to enable or disable the top gutter
pattern, which displays technical details about the print, out-
side the top edge of the print.
◆ Side Gutters
- allows you to enable or disable the side gut-
ter pattern, which fires all jets in a narrow, medium, or wide
pattern at the right and left edges of the print, for trouble-
shooting purposes.
◆ Service Station
- allows you to specify the print head ser-
vice station spit-and-wipe cycle: 30 seconds, 90 seconds
(default), or 30 seconds with spit only (no wipe).
◆ Humidity Sensor
- allows you to use the printer’s prepro-
grammed algorithm for slowing the print speed when the
ambient relative humidity is excessive, or allows you to spec-
ify a custom print speed. Slower print speeds allow ade-
quate drying under higher ambient relative humidity.
◆ Vacuum Fan Speed
- allows you to control the speed (and
therefore suction power) of the vacuum fans. Maximum
speed is recommended for most media, but lighter or polyes-
ter film media may require a slower speed for best results.
◆ AutoSet Summary
- allows you to enable or disable the
printed summary of an AutoSet calibration.
◆ Units -
allows you to display values in U.S. or metric units of
measure.
Modes
◆ Dryer Fan
- allows you to disable the dryer fan (if installed)
to avoid streaking output on films such as ViewThrough
Backlit.
◆ 3x Mode
- specifies the mode to use when the printer
detects that three four-color ink sets are loaded (if
upgraded).