Filter
Top Products
AutoTune Scheduling 4-5
AutoTune Scheduling
AutoTune is available only when the optional takeup system is
installed. When you use the AutoTune scheduler to run AutoSet,
AutoSet always performs its three calibrations without prompt-
ing the user or canceling due to too many bad jets. You can use
the Quality Check Mode feature to handle AutoSet errors, with
or without user intervention.
To run AutoSet at specified intervals (AutoTune):
1. On the control panel, press the
a
(Options) key to enter the
menu system.
2. Press the
c
key repeatedly to highlight the
Calibrate Printer
option.
3. Press
e
(Menu Select).
The Calibrate Printer menu appears.
4. Press the
c
key repeatedly to display the “AutoTune” option.
5. Press
e
(Menu Select).
The control panel prompts you to specify an AutoTune
interval.
6. Press
f
(Proceed).
The control panel displays this message:
Run AutoSet every 0 prints.
7. Press the
b
key repeatedly to increment the AutoTune inter-
val to the number of prints you desire.
8. Press
f
(Proceed).
9. Press the
d
(Menu Up) key repeatedly until the control panel
reads
Ready.
Quality Check Mode
When you run AutoSet manually, the software notifies you if
there are any jet or alignment problems so that they can be
addressed. When AutoTune runs AutoSet at scheduled intervals,
you can use the Quality Check Mode feature to handle AutoSet
errors. For instructions on setting the Quality Check Mode, see
page 2-8.