Filter
Top Products
100
Enhancements
Release K.13.16 Enhancements
Figure 20. Example of the Custom show interfaces Command
You can specify the column width by entering a colon after the column name, then indicating the
number of characters to display. In Figure 20 the Name column only displays the first four characters
of the name. All remaining characters are truncated.
Note
Each field has an fixed minimum width to be displayed. If you specify a field width smaller than the
minimum width, the information is displayed at the minimum width. For example, if the minimum
width for the Name field is 4 characters and you specify Name:2, the Name field displays 4 characters.
Parameters can be entered in any order. There is a limit of 80 characters per line; if you exceed this
limit an error displays.
Error Messages
Error Error Message
Requesting too many fields (total characters exceeds 80) Total length of selected data exceeds one line
Field name is misspelled Invalid input: <input>
Mistake in specifying the port list Module not present for port or invalid port: <input>
The port list is not specified Incomplete input: custom
ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 100/1000T 1 No 1000FDx Yes Auto
2 Huma 100/1000T 1 No 1000FDx Yes Auto
3 Deve 100/1000T 1 No 1000FDx Yes Auto
4 Lab1 100/1000T 1 No 1000FDx Yes Auto