Filter
Top Products
174
Software Fixes in Release K.11.12 - K.13.49
Release K.12.44
Release K.12.44
Not a general release.
■ Enhancement (PR_1000457691) — This enhancement allows the mapping of all
theoretically available VLAN IDs (1-4094) to an MSTP instance, even if some of the VLANs
are not currently configured on the switch. For more information, see “Release K.12.44
Enhancements” on page 65.
■ Enhancement (PR_1000457868) — Local Proxy ARP enhancement. For more
information, see “Release K.12.44 Enhancements” on page 65.
■ Enhancement (PR_1000456271) — PC attached to telephone. For more information, see
“Release K.12.44 Enhancements” on page 65.
Release K.12.45
The following problems were resolved in build K.12.45. (Never Released.)
■ STP (PR_1000449365) — ARP & MAC tables get out of sync after a spanning tree (MSTP
or RSTP) re-convergence. An ARP entry fails to be associated to the port even though the
MAC entry exists. This may result in an unexpected ping failure.
■ PIM (PR_1000450431) — IP Multicast Routing PIM-DM Stops Forwarding Flows, and the
event log reports:
PIM: Failed alloc[ation] of HW Flow for flow <multicast address>
■ SSH (PR_1000453226) — Configuration of SSH login to the manager mode (aaa
authentication ssh enable public-key
<enter>) triggers an error “Not legal combination of
authentication methods”, but it should be a valid command syntax.
■ Authentication (PR_1000454714) — Concurrent 802.1X and MAC-authentication does
not give the 802.1X value precedence. This fix gives 802.1X VLAN assignment precedence
over MAC auth RADIUS VLAN assignment.
■ SNMP (PR_1000389902) — The switch is not sending an "embedded URL" within the
SNMP trap for an FFI event to the PCM server monitoring traps. The embedded URL, if sent,
would allow someone looking at the log event on the PCM server to simply click on the URL
and be immediately connected to the switch.
■ CLI (PR_1000418891) — The Connection Rate Filter ignore list does not display properly
in the output for the show run command; the IP address and mask are incorrectly printed
on the next line.