Filter
Top Products
82
Enhancements
Release K.13.04 Enhancements
• The VRs operating VLAN can’t be configured as a tracking VLAN for that VR.
• Ports that are part of a trunk can’t be tracked.
• A port that is tracked can’t be included in a trunk.
• Trunks that are tracked can’t be removed; you are not able to remove the last port from
the trunk.
• LACP (active or passive) cannot be enabled on a port that is being tracked.
• If a VLAN is removed or a port becomes unavailable, the configuration is retained and
they are tracked when they become available again.
• After the Owner VR relinquishes control of its IP address, that IP address becomes
unavailable to all other applications and routing protocols such as RIP and OSPF.
• To avoid operational issues, it is recommended that VRRP is not run on the same
interface/VLAN with other routing protocols, such as RIP and OSPF.
Error Messages
Track Interface
Message Description
VR must be defined as “backup” first You have to declare a VR as Backup before assigning a
track interface to it.
Invalid input: <out of range value> You have to assign a valid port or trunk to the VR instance.
VR operation must be “down” prior to modifying VR’s
parameters
You cannot change the track interface when the VR is
active. Use the no enable command to disable the VR.
Can’t track a port that is part of a trunk You can’t configure tracking on a port that is a member of
a trunk.
Tracking is disabled on owner You can’t configure a track interface on an Owner VR.
Cannot remove trunk being tracked by VRRP You can’t remove a trunk that is being tracked by a VR
Cannot enable LACP on a VRRP tracked port You can’t enable LACP on a port that is being tracked by a
VR.
Too many entities to track You have selected too many entities to be tracked by the
VR.
Cannot track trunk/LACP member You can’t track the specified trunk or LACP member.
VRRP tracked port is not allowed in trunk You can’t add this tracked port to a trunk.
VRRP tracked port is not allowed in LACP You can’t use LACP with the tracked port.
Operation is not permitted on VR when it is configured as
owner or is uninitialized.
The VR must be a Backup and initialized in order to execute
the operation.