Filter
Top Products
195
Software Fixes in Release K.11.12 - K.13.49
Release K.13.18
■ SNMP (PR_1000761379) — When an SNMP get is used to gather statistics, the interface
B1 on a J8702A module only updates its SNMP counters on every other query.
■ SNMP (PR_0000001807) — Use of a correctly configured third party utility to connect to
the switch via SNMPv3 may result in the following event log message.
SNMP Security access violation from <ip address>
■ PIM/Config (PR_0000002040) — PIM configurations mapped to VLANs are incorrectly
mapped after updating from K.12.xx to K.13.xx. Note that while this fix addresses the way
the configuration is updated, rolling back the software while using the same configuration
can still result in corruption in PIM configurations mapped to VLANs.
Release K.13.18
The following problems were resolved in release K.13.18 (never released).
■ UDLD (PR_0000002473) — UDLD protocol packets received on a (non-UDLD) trunk
port are incorrectly forwarded out of same port they are received on, resulting in high CPU
usage on the switch.
■ Enhancement (PR_1000406763) — New commands were added to the CLI response to
the "show tech" command. For more information, see “Release K.13.18 Enhancements” on
page 109.
■ SSH (PR_0000002946) — ProCurve 8212zl switches do not automatically create the SSH
folder on /cfa0; the result is that attempts to generate a crypto key may result in the following
error.
Installing new RSA key. If the key/entropy cache is depleted, this
could take up to a minute.
Operation aborted.
■ ACL (PR_0000004860) — Mirrored ACL packets that match deny statements, are
mirrored; the correct behavior is that only packets matching permit statements should be
mirrored.
■ Crash (PR_0000004166) — When the PIM Sparse Mode "trap all" parameter is configured
and the link to PIM neighbor is disabled, the switch will crash and may report a message
similar to the following.
Software exception at exception.c:501 -- in 'mPimsmCtrl', task ID =
0x8215d30 Memory system error at 0x7c838f0 – memPartFree
■ Mirror/CLI (PR_0000003269) — The CLI incorrectly configures the option
"no-tag-added" across multiple mirror sessions, resulting in the wrong output saved to the
config file.