Filter
Top Products
154
Software Fixes in Release K.11.12 - K.13.49
Release K.11.44
The following problems were resolved in release K.11.43 (not a general release)
■ Crash (PR_1000307842) — When deleting/removing CLI ACLs, IDM ACLs, management
VLAN, or virus throttle lockouts, switch crashes with error similar to:
"Delete virtual meter with nonzero rule RefCount".
■ Crash (PR_1000334982) — When Web authentication is used with open VLANs, a softwar e
exception may occur, with the switch reporting something similar to this.
Software exception at wma_vlan_sm.c:289 -- in 'mWebAuth',
task ID = 0x81e408e0 -> ASSERT: failed
■ Enhancement (PR_1000358903) — 802.1X Controlled Directions enhancement. With this
change, Administrators can use “Wake-on-LAN” with computers that are connected to ports
configured for 802.1X authentication.
■ VRRP (PR_1000356388) — VRRP returns the physical MAC address instead of the virtual
MAC address when replying with proxy-ARP.
Release K.11.44
The following problems were resolved in release K.11.44 (not a general release)
■ Enhancement (PR_1000361504) — This enhancement allows STP to detect and block
network topology loops on a single port.
Release K.11.46
Version K.11.45 was never released.
The following problems were resolved in release K.11.46 (not a general release)
■ CLI (PR_1000345301) — The output from the "show config state" CLI command doesn't
always report changes made to the configuration.
■ CLI (PR_1000305584) — The output from the "show power" commands on the ProCurve
3500yl switches references slot letters when it should display port numbers.
■ Crash (PR_1000357083) — The switch management may run out of packet buffers and
crash with a message similar to:
Software exception at ngDmaTx.c:722 -- in 'tDevPollTx', task ID = 0x4305c504 ->
HW DMA DRIVER unable.
■ Hang (PR_1000359640) — The switch may hang on initialization and become
unresponsive.