Filter
Top Products
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 159
switch
Initiates an edit session in which to change switch configuration settings. The system displays
each parameter one line at a time and prompts you for a value. For each parameter, enter a new
value or press Enter to accept the current value shown in brackets. Table 46 describes the Set
Config Switch parameters.
Table 46 Set Config switch parameters
Parameter Description
AdminState Switch administrative state: Online, Offline, or Diagnostics. The default is
Online.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forwarding of broadcast
frames. The default is True.
InbandEnabled Inband management. Enables (True) or disables (False) the ability to
manage the switch over an ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True) or disables (False) the
monitoring of target and initiator device information. The default is True.
FDMIEntries The number of device entries to maintain in the FDMI database. Enter a
number from 0–1000. The default is 1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the domain ID.
The default is False.
SymbolicName Descriptive name for the switch. The name can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is
McDATA4GbSAN.
R_A_TOV Resource Allocation Timeout Value. The number of milliseconds the
switch waits to allow two ports to allocate enough resources to establish
a link. The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port is to wait
for errors to clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch selection algorithm. 1 is
high, 255 is low. The default is 254.
ConfigDescription Switch configuration description. The configuration description can be
up to 32 characters excluding #, semicolon (;), and comma (,). The
default is Default Config.
InteropMode Interoperability mode. Choose from the following:
• Use Standard to connect to FC-SW-2 compliant switches including
McDATA switches in Open Fabric Mode. This is the default.
• Use the McDATA Fabric Mode to connect to McDATA switches in
McDATA Fabric Mode.