Filter
Top Products
Registration assembly
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Secondary transfer assembly. See
Secondary transfer assembly on page 96.
●
Intermediate transfer belt (ITB). See
Intermediate transfer belt (ITB) on page 98.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the
registration assembly.
●
RD sensor assembly. See
Registration density (RD) sensor assembly on page 143.
TIP: Removing the RD sensor assembly makes it much easier to reinstall the registration
assembly.
●
Power supply fan and fan duct. See
Power supply fan and fan duct on page 147.
Remove the registration assembly
NOTE: If a replacement registration assembly is installed, you must use the control panel menus to
reset the registration-roller count.
1. Remove two screws (callout 1).
Figure 2-117 Remove the registration assembly (1 of 8)
1
150 Chapter 2 Removal and replacement ENWW