Filter
Top Products
57.00.0Y Error To continue, turn off then on
Description
Fan error
Recommended action
57.00.03
Power supply fan (FM1) failure
1. Turn the product off, and then on. Listen for fan noise at the front lower-left corner of the product. If
no noise is heard, replace the power supply fan (FM1).
2. If this part has been removed or replace, check the connector (J119) on the DC controller PCA.
3. Measure the voltage between the connectors (J119-1 and J119-3) on the DC controller PCA
immediatly after the product power is turned on. If the voltage changes from 0 VDC to
approximately 24 VDC, replace the fan (FM1).
57.00.04
Cartridge fan (FM2) failure
1. Turn the product off, and then on. Listen for fan noise at the front lower-right corner of the product.
If no noise is heard, replace the cartridge fan (FM2).
2. If this part has been removed or replace, check the connector (J26) on the cartridge fan, connector
(J262) on the high-voltage power supply (lower), and the connector (J114) on the DC controller.
3. Measure the voltage between the connectors (J262-1 and J262-3) on the high-voltage power
supply (lower) immediatly after the product power is turned on. If the voltage changes from 0 VDC
to approximately 24 VDC, replace the fan (FM2).
57.00.05
Delivery fan (FM3) failure
1. Turn the product off, and then on. Listen for fan noise at the lower back-center of the product. If no
noise is heard, replace the delivery fan (FM3).
2. If this part has been removed or replace, check the connector on the intermediate connect board.
3. Measure the voltage between the connectors (J262-1 and J262-3) on the high-voltage power
supply (lower) immediatly after the product power is turned on. If the voltage changes from 0 VDC
to approximately 24 VDC, replace the fan (FM3).
58.00.04
Description
The low-voltage power supply is defective.
428 Chapter 3 Solve problems ENWW