Filter
Top Products
Table 3-21 General Settings menu (continued)
First level Second level Third level Fourth level Values Description
Transfer Control Normal*
Alternate 1
Alternate 2
Alternate 3
Use this setting to
correct transfer issues
in print jobs. Turn this
feature on if green,
mottled images are
printed on the page.
Note that using this
mode can increase
problems with blurry
images or specks of
toner on the leading
or trailing edge of
the paper. The
default setting is
Normal. The
Alternate 1 setting
reduces the T1 bias
and should be used
when re-transfer
occurs. The
Alternate 2 setting
increases the inter-
page gap. Using this
setting reduces
throughput and might
decrease the print-
cartridge life. The
Alternate 3 setting
applies the
Alternate 1 and
Alternate 2 settings
at the same time. Use
this setting if the first
two settings do not
correct the problem.
Fuser Temp Normal*
Alternate
If you are seeing a
faint image of the
page repeated at the
bottom of the page
or on the following
page, you should first
make sure the Paper
Type and Print Mode
settings are correct
for the type of paper
you are using. If you
continue to see ghost
images on your print
jobs, set the Fuser
Temp feature to the
Alternate setting.
344 Chapter 3 Solve problems ENWW