Filter
Top Products
Table 3-47 Print modes under the Adjust Paper Types sub menu (continued)
Resistance Mode Set to Up to resolve print-quality issues caused by poor
secondary transfer in low-humidity environments with resistive
or rough surface media.
Humidity Mode With glossy film, set to High when the product is in a high-
humidity environment and print-quality defects occur on HP
Tough Paper or Opaque film.
With transparencies, set to High when the product is in a
high-humidity environment and print-quality defects occur on
color transparencies on the first page of a print job.
With all other paper types, set to High when the product is in
a high-humidity environment and light density occurs on the
first page of a print job.
Pre-Rotation Mode Set to Alternate 1 when horizontal banding occurs with the
drum pitch.
Set to Alternate 2 when problems like fade finger (trailing
edge toner starvation) occurs after high coverage continuous
printing.
Fuser Temp Mode If you are seeing a faint image of the page repeated at the
bottom of the page or on the following page, first make sure
the paper type (Adjust Paper Types menu) and Print
Mode settings are correct for the type of paper you are
using. If you continue to see ghost images on your print jobs,
set the Fuser Temp feature to one of the settings.
Normal
Up
Down
Paper Curl Mode Use in high-humidity and high-temperature environments. The
Reduced setting decreases fuser temperature and increases
the interpage gap.
Table 3-48 MP modes under the Optimize submenu
Normal Paper Set to Smooth when printing on smooth paper of normal
weight.
Heavy Paper Set to Smooth when printing on smooth, heavy media types.
Envelope Control Use this mode if envelopes are sticking together due to
moisture in the envelope adhisive.
Normal
Reduced Temperature Multipurpose Mode
Environment Set to Low Temp if the product is operating in a low-
temperature environment and you are having problems with
print quality such as blisters in the printed image.
ENWW
Use manual print modes
495