2. Use a small flat blade screwdriver to carefully remove four locking clips (callout 1).
CAUTION: Do not damage the PCA with the screwdriver.
Figure 2-140 Remove the high voltage power supply lower (2 of 4)
1
3. Disconnect one connector (callout 1; J114), and then release four clips (callout 2).
NOTE: To locate DC controller connector locations, see DC controller PCA on page 284.
Figure 2-141 Remove the high voltage power supply lower (3 of 4)
2
1
168 Chapter 2 Removal and replacement ENWW