4. Rotate the top of the power supply away from the chassis, and then disconnect one connector
(callout 1). Remove the power supply.
Reinstallation tip Make sure the cables do not get stuck behind or damaged by the sheet
metal.
Figure 2-142 Remove the high voltage power supply lower (4 of 4)
1
Reinstall the high voltage power supply lower
When you reinstall the power supply, look through the holes in the PCA and make sure that the high
voltage contact springs are correctly seated against the PCA.
Figure 2-143 Reinstall the high voltage power supply lower
ENWW
Internal assemblies
169