Filter
Top Products
Removal and Installation
8-76
HP DesignJets 500, 510 and 800 Series Printers Service Manual
Encoder Strip
Removal
WARNING Switch off the printer and remove the power cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Hand Cover - Refer
to Page 8-5.
2. Remove the Right Hand Cover - Refer
to Page 8-7.
3. Remove 1 T-15 screw (Type E) that
secures the Encoder Strip to the Left
Encoder Holder.
4. Release the Encoder Strip from the
left hand side.
NOTE The Encoder Strip is sharp so
be careful when touching it.