Filter
Top Products
Troubleshooting
Solving Miscellaneous Problems
11-55
If the Printer Waits Too Long to Print a Nest
n Change the Nest wait setting. See page 7-15.
If the Bail (Black Metal Bar) does not Lower All the Way
n If the bail (the black metal bar just inside the printer’s window) will not lower all
the way, check for obstructions underneath it.
n Make sure the cutting carriage is pushed all the way to the left.
The Media coming from the Printer is Fed Back into the
Printer causing a Media Jam.
n Lower the media lever and pull the media which has been fed back into the
printer until it is released.
n Go to Utilities/Move Media press the
↓
key to move the “media backwards”.
This will unblock the printer and you will be able to retrieve your media.
n If the media is damaged, cut and reload the media as described on page 3-13,
Loading Roll Media.