Filter
Top Products
Front-Panel Messages
Message Explanations and Actions
12-7
INK SYSTEM
ERROR
xxxxxx
The printer has detected an error in the ink system, as shown in earlier messages.
Printing will be disabled until the error has been corrected. If more than one error is
pending, the one with the highest number, corresponding to the most severe error, will
be displayed.
Possible error codes (xxxxxx) are:
• 58.... See the message “Incorrect ink system”
• 65.... or 66.... See the message “Printhead failure”
• 67.... See the message “Printhead contact error”
• 72.... See the message “Ink cartridge removed”
• 73.... See the message “Head cleaner removed”
• 74.... See the message “Printhead removed”
• 88.... See the message “Mixed ink system”.
Press the Replace Ink System key to replace the erroneous ink systems in order to
print with your printer again. See 11-38, Checking Ink Systems.
Press the Enter key to access the main front panel menus.
Install complete Ink system replacement has been completed successfully.
Resume normal operations.
Lift lever after
aligning
You have lowered the media lever to align the media with the entry platen.
Lift the lever at the right edge of the paper path on the printer when you’ve finished
aligning the roll media as instructed.
Lift lever to
continue
The media lever was lowered while the processor was busy.
Lift the lever at the right edge of the paper path on the printer.
Load arrow edge
print side down
Remove the accuracy calibration print, turn it so that the edge with the arrows printed
on it is print-side down, then load that edge into the printer.
Load cancelled
Remove media
The Cancel key was pressed while media loading was in progress.
Remove media.
Load error
Remove media
Media was inserted with the media lever raised.
Lower the lever and reload the media.
Load media for
calibration
Load media to proceed with calibration.
Load media
to align printheads
Load media to proceed with printhead alignment.
Message Explanation and Action