Filter
Top Products
Front-Panel Messages
Message Explanations and Actions
12-20
STATUS
Paused
You have pressed the Pause key. The printer will remain paused until you press the
Pause key again.
Press the Pause key again when you are ready.
STATUS
Printing
The printer is printing.
Wait for the printing to complete.
STATUS
Printing (Special)
The printer is printing with a special print mode controlled by your software rather
than by the printer.
Wait for the printing to complete.
STATUS
Processing
The printer has received a file from your software and is processing it ready to print.
Wait for the printing to complete.
STATUS
Ready
The printer is ready to print.
Send a file to the printer.
STATUS
Ready for media
The printer is ready for you to load media.
Load appropriate media.
STATUS
Receiving
The printer has received data.
Wait for further messages.
STATUS
Recovering printhds.
The printer is recovering the printheads after an ink system replacement process
(only for UV Pigmented inks), or you have initiated the printhead recovery
procedure under Utilities / Service Tests/ Recover Printheads.
Wait for the printhead recovery procedure to complete.
STATUS
Refilling XmXX s
The printer is filling the printheads. (This message only applies to firmware
revision levels A.02.08 or higher.)
Wait for the process to complete.
STATUS
Returning printheads
The ink system replacement process has been cancelled, and the printhead carriage
is returning to its station at the right of the printer.
Wait until the carriage is in position.
STATUS
Roll feed edge trim
The printer is trimming the edge of roll media.
Wait until the media has been trimmed.
Message Explanation and Action