Filter
Top Products
15
Chapter 1, Getting Started
Step 2: Load and Run the CDMA/PCS BS Test Software
Step 2: Load and Run the CDMA/PCS BS Test Software
The next step is to get the CDMA/PCS BS Test Software loaded into the Test Set
and running on the IBASIC controller. Locate the memory card supplied with the
PCS Interface and follow the steps of figure 3 and figure 4.
Figure 3
Press PRESET.
Insert the
System Utility
Software card.
Press
POWER.
1
4
3
Wait for display to
appear
(approximately 20
seconds).
2
Continued on the following page