Filter
Top Products
18
Chapter 1, Getting Started
Step 3: Configure the Software
Step 3: Configure the Software
The first time you run the Software you must enter information about your setup
and the base station being tested. Use these steps:
Scroll to and select Base Station Power Out
and enter the level of your transmitted signal.
Scroll to and select the clock frequency of the
timebase signal at the SYNTH REF IN port.
From the CDMA PCS Main Menu, scroll to and
select Configuration Information Menu.
Scroll to and select Base Station Reference
Freq.
1
3 4
2
Quit
Configuration Information Menu
Base Station Channel . . . . . . . . . 220
Base Station PN Offset . . . . . . . . 16
Search for PN Offset
Go to Spectrum Analyzer @ Present Chan
Go to Spectrum Analyzer & Enter Freq
Go to Code Domain Analyzer Screen
Perform Average Power Measurements
Measure Rho Parameters
Set up CDMA Generator
Check Even Second Clock
CDMA PCS Main Menu
Return to Main Menu
Base Station Channel . . . . . . . . . 220
Base Station PN Offset . . . . . . . . 16
Base Station Reference Freq. . . 19.6608 MHz
Base Station Reference To . . . . SYNTH REF IN
Base Station Power Out . . . . . . . 1.00000 Watt(s)
TX Measurement Path Loss . . . . . .5 dB
RX Measurement Path Loss . . . . 4.0 dB
Connection Drawing Menu
PCS Band = North American Band
Beep = Off
Save Info To Memory
Load Info From Memory
Purge Info From Memory
Configuration Information Menu
1
1 . 2288
2
2 . 4576
4 . 9142
5
9 . 8304
10
15
19.6608
Select New Reference Frequency
Continued on the following page
Configuration Information Menu
Typical reference
frequencies are
19.6608 MHz and
10 MHz.
Return to Main Menu
Base Station Channel . . . . . . . . . 220
Base Station PN Offset . . . . . . . . 16
Base Station Reference Freq. . . 19.6608 MHz
Base Station Reference To . . . . SYNTH REF IN
Base Station Power Out . . . . . . . 1.00000 Watt(s)
TX Measurement Path Loss . . . . . .5 dB
RX Measurement Path Loss . . . . 4.0 dB
Connection Drawing Menu
PCS Band = North American Band
Beep = Off
Save Info To Memory
Load Info From Memory
May be
approximate.