Filter
Top Products
56
Chapter 3, Operating Overview
Purging Configuration Information from Memory
Purging Configuration Information from Memory
The information about your setup and base station entered into the
Configuration Information Menu can be saved in memory. This data is
loaded automatically when you re-run the Software. In some instances however,
you might wish to use default data. If so, you must clear your saved values from
memory. This procedure describes steps for manually purging the memory.
Requirements • Data previously saved to a RAM disk.
Steps 1 From the main menu, choose the Configuration Information Menu.
2 Scroll down to Purge Info From Memory and press the knob. The purging
process takes only a fraction of a second. The next time the Software is run, the
Configuration Information Menu will be loaded with default values.
3 To return to the main menu level, press the Main Menu (k5) key.
Notes The fact that configuration information has been purged from memory is shown
in the Configuration Information Menu whenever you purge the data
manually, using the steps outlined above.
See "Saving Configuration Information to Memory" on page 54 for a description
of saving the settings to memory.