Filter
Top Products
17
Chapter 1, Getting Started
Step 2: Load and Run the CDMA/PCS BS Test Software
Navigation of the
CDMA/PCS BS
Test Software
After the Software has loaded, you should see the CDMA/PCS BS Test
Software’s main menu screen on the display of the Test Set (see figure 5).
Important features of this screen are indicated in the figure with notes on their
use.
Figure 5 CDMA/PCS Test Software main menu features
Knob
The knob controls the
cursor position on the
display and is
sometimes used to
make numeric entries.
USER Keys and their Fields
The USER Keys (k1 - k5) correspond
to fields 1-5 at the top right corner of
the test screen. They are used for
navigation through menus and for
making selections. In most lower-level
menus, a “Prev Menu” key is provided
to take you up one menu level.
Entry Fields
Some main menu selections are entry fields. When these
are selected, a highlighted area appears and you may key
in a value with the DATA keys, or rotate the knob to
change the value in the field. When the desired value is
set, press the knob or the ENTER key.
Tuned Frequency
This area displays the frequency
settings for the CDMA analyzer
and signal generator.
Main Selection and Cursor Control
Some menu selections open lower-level
menus, others allow entry of numeric
data. To select a menu item, rotate the
knob until the cursor is front of the
selection and press the knob.
Quit