Filter
Top Products
3-18
HP 8517B S-Parameter Test Set Manual
Operating the HP 8517B Test Set
Using Anti-Rotation Clamps
Aligning the thumb-screw
See Figure 3-8. Ensure that the thumb-screw is aligned with the counter-sink
hole on the clamp’s body.
1. Push the clamp toward the test set front panel.
2. Finger-tighten the thumb-screw. The cable cannot be damaged if the
thumb-screw is tightened too tightly.
Figure 3-8 Aligning the Thumbscrew With the Counter-Sink Hole
Attaching the second clamp
To complete the anti-rotation clamp installation, repeat the steps above,
beginning at step 1 to attach the second clamp.