Filter
Top Products
HP 8517B S-Parameter Test Set Manual
7-1
7
HP 8517B Replaceable Parts
Introduction
This section provides information about ordering replacement parts. Parts
that can be replaced include major assemblies and chassis hardware, but not
individual pieces of major assemblies. Table 7-1 lists the major assembly
reference designations and abbreviations used in the parts lists.
Rebuilt-Exchange
Assemblies
Rebuilt-exchange assemblies (R-E assemblies) cost less than new
assemblies. They are available through the rebuilt-exchange program.
Factory rebuilt (repaired and tested) assemblies meet all factory
specifications required of a new assembly. They are available on an
exchange (trade-in) basis only. Defective assemblies must be returned for
credit. Figure 7-2 illustrates the rebuilt-exchange procedure. The rest of the
figures in this chapter provide parts information. If you have any questions,
contact the HP Sales and Service office in your region.
Replaceable Parts List Use the illustrations in this chapter to help locate and identify HP 8517B
replaceable parts. Each illustration is accompanied by a replaceable parts list
that includes the following information:
• Hewlett-Packard part number.
• Part quantity as shown in the corresponding figure. (There may or may
not be more of the same part located elsewhere in the instrument.)
• Part description, using the abbreviations found in Table 7-3.
NOTE
A typical manufacturer of the part is identified by a five-digit code (refer to
the Manufacturers Code list in Table 7-2) and given only if a part is available
from an alternate supplier (other than Hewlett-Packard).
.