Filter
Top Products
Tape Drives: Monitoring and Recovery
HP Integrity NonStop NS-Series Operations Guide—529869-005
11- 9
Recovery Operations Using SCF
Recovery Operations Using SCF
These SCF commands are available for controlling TAPE objects:
The SCF Reference Manual for the Storage Subsystem describes these commands.
Related Reading
For more information about tapes and tape drives, refer to the documentation listed in
Table 11-2.
.
SCF Command Description
PRIMARY Causes the backup processor of a tape drive to become the
primary processor and the primary processor of the drive to
become the backup processor.
RESET Puts a tape drive in a state from which it can be restarted.
START Initiates the operation of a tape drive.
STATUS Displays current status information about a tape drive.
STOP Terminates the operation of a tape drive in a normal manner.
Table 11-2. Related Reading for Tapes and Tape Drives (page 1 of 2)
For Information About... Refer to...
Tape drives Integrity NonStop NS-Series Supported Hardware
BACKUP, RESTORE, and
BACKCOPY utilities
Guardian Disk and Tape Utilities Reference Manual (for
Enscribe and SQL/MP files)
BRCOM utility Backup and Restore 2.0 Manual (OSS and SQL/MX
files)
OSS pax
utility Open System Services Management and Operations
Guide (backup and restore of OSS files)
Performing system operations
involving tape drives
Guardian User’s Guide
Replacing tape drives Support and Service Library
on page 1-12
Recovery operations for generic
tape processes
SCF Reference Manual for the Kernel Subsystem
Recovery operations for tape
drives
SCF Reference Manual for the Storage Subsystem
Configuring tape drives SCF Reference Manual for the Storage Subsystem
Starting and stopping tape drives SCF Reference Manual for the Storage Subsystem
Using the MEDIACOM utility DSM/Tape Catalog User’s Guide
DSM/Tape Catalog Operator Interface (MEDIACOM)
Manual
Guardian User’s Guide