Filter
Top Products
(CAT 5) cable is required. A UTP Category 3 (CAT 3) cable is applicable when
connecting only to the 10BASE-T port at 10 Mbps. Figure 3-83 shows the cable
specifications.
Table 3-96 Pin arrangement on the device side (10MBASE/100MBASE interface)
Pin No. Specifications
1Transmit(+) (A)
2 Transmit (-) (a)
3 Receive (+) (B)
4Unused (C)
5 Unused (c)
6 Receive (-) (b)
7Unused (D)
8 Unused (d)
Note: Because of being a twisted pair cable, make pairs of (A) and (a), (B) and (b), (C) and (c), and (D)
and (d) using the above pin assignment. For pins other than these, do not care about the pairing, either
unconnected or connected can be accepted.