Filter
Top Products
2 - 21
<F0> Break Character
When your keyboard detects that any key is being pressed, released, or held down, the keyboard sends a packet of infor-
mation known as a “scan code” to your computer. There are two different types of scan codes: “make codes” and “break
codes.” A make code is sent when a key is pressed or held down. A break code is sent when a key is released. The fol-
lowing selections allow you to suppress or transmit the character sequence of the break code. Default = Transmit.
Keyboard Wedge Defaults
If you want the custom keyboard wedge default settings restored to your scanner, scan the Keyboard Wedge Defaults bar
code below. This resets the scanner to the custom default settings (see Setting Custom Defaults on page 1-5). If there are
no custom defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified
through the custom defaults will be defaulted to the factory default settings.
Suppress
* Transmit
Keyboard Wedge Defaults