Filter
Top Products
4 - 4
To change the number of error beeps, scan the following bar code and then scan a digit (1-9) bar code and the Save bar
code on the Programming Chart inside the back cover of this manual. Default = 1.
LED Indicators
The green and red LEDs can be programmed to be On or Off and at different brightness levels to indicate various scanner
states. Use the following bar codes to program the LED indicators.
LED Settings
Default = Red LED On with Laser/Red LED Blinks when Battery is Low, Green LED On with Good Scan.
Number of Error Beeps/LED Flashes
Red LED Off
Green LED Off
Red LED On with Good Scan
* Green LED On with Good Scan
Red LED On with Laser
* Red LED On with Laser/
Red LED Blinks when Battery is Low
Green LED On with Laser
Red LED On when CodeGate
Disabled