Filter
Top Products
4 - 8
Manual Activation Laser Timeout - Button Settings
You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when the button is
held down, and after it is released. Set the length (in milliseconds) for a timeout by scanning one of the following bar codes,
then setting the timeout (from 1-65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save.
Default = Button Hold In-Stand 5000 ms, Button Hold Out-of-Stand 5000 ms, Button Release In or Out-of-Stand 0.
* End Manual Activation After
Good Read In-Stand
Do Not End Manual Activation
After Good Read Out-of-Stand
* End Manual Activation After
Good Read Out-of-Stand
Laser Timeout - Button Hold
In-Stand
Laser Timeout - Button
Release In-Stand
Laser Timeout - Button Hold
Out-of-Stand
Laser Timeout - Button
Release Out-of-Stand