Filter
Top Products
3 - 6
Reset Scanner
Scanning this bar code reboots the scanner and causes it to relink with the base.
Scanning While in Base Cradle
If you want to be able to scan bar codes while the scanner is in the base, scan the following Scanning in Cradle On bar code.
If you want to only allow scanning when the scanner is out of the base, scan Scanning in Cradle Off. Default = Scanning in
Cradle On.
Note: When Scanning in Cradle Off is selected, the scanner will not scan any bar codes while it is in the base. It will only scan
when removed from the base.
Paging
Paging Mode
By default, the paging button on the base pages the scanner associated with that base. If you want the paging button on
your base to be disabled, scan the following Paging Mode Off bar code. When Paging Mode is off, the base will no longer
page the scanner when the button is pressed. The red LED on the base will remain lit to indicate that Paging Mode is off.
(This light will go out when the button is pressed, then back on when it’s released.) Default = Paging Mode On.
Reset Scanner
Scanning in Cradle Off
* Scanning in Cradle On
* Paging Mode On
Paging Mode Off