Filter
Top Products
4 - 7
Presentation Mode with CodeGate Out-of-Stand: When the scanner is not in the stand, it automatically detects bar
codes and decodes them. However, the data is not transmitted until you press the button. The laser remains on briefly
after the transmission. (If you are accustomed to a Voyager 9540, this setting is the same as the 9540’s default.)
Manual Activation Mode
In Manual Activation Mode, you must press the button to scan a bar code. The scanner scans until a bar code is read, or
until the button is released. Default = Manual Activation Mode On In-Stand, Manual Activation On Out-of-Stand.
End Manual Activation After Good Read
After a bar code is successfully read, the laser can be programmed either to remain on and scanning, or to turn off. When
End Manual Activation After Good Read is enabled, the laser turns off and stops scanning after a good read. If you scan
Do Not End Manual Activation After Good Read, the laser remains on after a good read, but the button must be pressed
to scan the next bar code. Default = End Manual Activation After Good Read.
Presentation Mode
Out-of-Stand
Presentation Mode with
CodeGate Out-of-Stand
Manual Activation Mode Off
In-Stand
* Manual Activation Mode On
In-Stand
Manual Activation Mode Off
Out-of-Stand
* Manual Activation Mode On
Out-of-Stand
Do Not End Manual Activation
After Good Read In-Stand