Filter
Top Products
3 - 17
To relink to the charge base, scan the Base BT Connection bar code.
Changing the Scanner’s Bluetooth PIN Code
Some devices require a PIN code as part of the Bluetooth security features. Your scanner’s default PIN is 0000, which you
may need to enter the first time you connect to your non-base Bluetooth device. To change the PIN, scan the following bar
code and then scan the appropriate numeric bar codes from the Programming Chart inside the back cover of this manual.
(The PIN code must be between 1 and 16 characters.) Scan Save to save your selection. Default = 0000.
Minimizing Bluetooth/ISM Band Network Activity
The following settings can help you customize the relinking behavior of the cordless system to obtain the best compromise
between convenience and low interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless networks, cordless phones, and Bluetooth.
Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins the relink process when a loss of connection is
detected. When the Auto Reconnect On bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
The following table shows the results of the Auto Reconnect On and Off settings:
Event Auto Reconnect On Auto Reconnect Off
Scanner out of range Relink occurs automatically. If maximum
number of link attempts is unsuccessful,
then the scanner must be relinked by
either pressing the scanner’s button or
placing the scanner in the base. (See
"Maximum Link Attempts" on page 3-18.)
The scanner is relinked by pressing
the button.
Non-Base BT Connection
Base BT Connection
Bluetooth PIN
* Auto Reconnect On
Auto Reconnect Off