Filter
Top Products
4 - 3
Beeper Pitch – Error
The beeper pitch codes modify the pitch (frequency) of the sound the scanner emits when there is a bad read or error.
Default = Razz.
Beeper Duration – Good Read
The beeper duration codes modify the length of the beep the scanner emits on a good read. Default = Normal.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of beeps will be applied to the
beeper and LED in response to a good read. For example, if you program this option to have five beeps, there will be five
beeps and five LED flashes in response to a good read. The beeps and LED flashes are in sync with one another.
Note: The LEDs can also be programmed separately. See LED Settings on page 4-4.
To change the number of beeps, scan the following bar code and then scan a digit (1-9) bar code and the Save bar code on
the Programming Chart inside the back cover of this manual. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or error can be programmed from 1 - 9. For
example, if you program this option to have five error beeps, there will be five error beeps and five LED flashes in response
to an error.
Note: The LEDs can also be programmed separately. See LED Settings on page 4-4.
* Razz (100 Hz)
Medium (2000 Hz)
High (4200 Hz)
* Normal Beep
Short BeepShort Beep
Number of Good Read Beeps/LED Flashes