Filter
Top Products
4 - 11
Object Detection Laser Timeout
You can set a timeout for the length of time the laser remains on and attempting to decode bar codes after an object is
detected. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-
65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 ms.
Object Detection Distance
When the scanner is in the stand and you are using Object Detection Mode, you can set the distance range for detecting
objects. Short sets the scanner to detect objects approximately 5 inches (12.7cm) away from the nose. Long sets it to
detect objects approximately 10 inches (25.4cm) away. Default = Short In-Stand, Long Out-of-Stand.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the Character Activation Laser Timeout (page 4-12), the deactivation character is
received (see Deactivation Character on page 4-13), or a bar code is transmitted. Scan the following On bar code to use char-
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
Object Detection Laser
Timeout In-Stand
Object Detection Laser
Timeout Out-of-Stand
* Short
In-Stand
Long
In-Stand
Short
Out-of-Stand
* Long
Out-of-Stand
* Off