Filter
Top Products
Print Server Administration User’s Guide
66 EtherP Admin Administration
SNMP community names, or the list of SNMP trap recipients. To change these
TCP/IP settings,
1. From the main menu, choose TCP/IP Configuration. The print server will
display the TCP/IP Configuration menu.
[TCP/IP Configuration]
1 - IP Address <168.8.100.52>
2 - Subnet Mask <255.255.0.0>
3 - Default Gateway <168.8.100.254>
4 - SNMP Community
5 - SNMP Traps
6 - IP Assignment Method <Manual>
0 - Return to Main Menu
Enter Selection:
2. To change the IP address, local subnet mask, or default gateway, choose the
appropriate menu item. The print server will prompt you for a new value for
the setting. Enter the new value and press Enter.
To change the SNMP community names, choose the appropriate menu item. The
print server will display the SNMP Community menu:
[SNMP Community]
1 - Commumity Name 1 <public>
2 - Community Access 1 <Read/Write>
3 - Commumity Name 2 <>
4 - Community Access 2 <Read Only>
5 - Commumity Name 3 <>
6 - Community Access 3 <Read Only>
0 - Return to TCP/IP Menu
Enter Selection:
For each of the three community name “slots” that the print server supports, you
can set the community name and the level of access (read-only or read/write) that
requests using that community name have. SNMP-compatible Network
Management System (NMS) stations can use the community names you have set
to access management information and statistics collected by the print server.
To change an entry, select the corresponding menu item. When the print server
prompts you for the new value, enter it and press Enter. When you are done
changing community name settings, choose 0 to return to the TCP/IP
Configuration menu.
To modify the SNMP trap settings, choose the appropriate menu item from the
TCP/IP configuration menu. The print server will display the SNMP Trap menu: