Filter
Top Products
Table 6. Troubleshooting charts
Device Suggested action
Blade server problem
Blade servers turn off for no
apparent reason.
All blade bays must have a blade server, expansion unit, or filler blade in them. Blade
bays that do not have these items installed or have them installed improperly disturb
airflow in the BladeCenter T unit with an adverse effect on BladeCenter T unit
cooling. If the BladeCenter T unit begins to overheat, blade server processors will
begin to slow down and will eventually turn off the system.
Blade server does not turn
on, the amber system-error
LED on the BladeCenter T
system-LED panel is lit, the
amber blade error LED on the
blade server LED panel is lit,
and the system-error log
contains the following
message: ″CRUs
MisMatched″.
The problem occurs after installing the second microprocessor option or after
replacing a failed microprocessor in a two-way Blade server.
The processor with the lowest feature set and stepping level must be used as the
Bootstrap Processor (BSP). This processor must be in the Microprocessor 1 location.
Switch the processors in the Microprocessor 1 and Microprocessor 2 locations.
Some components do not
report environmental status
(temperature, voltage).
The green status dot for a component is not automatically a link to environmental
information (temperature and voltage) for the component. Only the management
module and blade servers have environmental information, and only the green dot for
those components contains a link to environmental information.
Switching KVM control
between blade servers gives
USB device error.
If a blade server is under heavy load, it can take several minutes before it
enumerates the USB devices connected to it. If control of the KVM and media tray is
switched away from the blade server before this enumeration is complete, a USB
device installation error might be displayed. Do not switch KVM control between
blade servers until the mouse and keyboard are both working on the blade server
that has control of the KVM and media tray.
“Unsafe Removal of Device”
error message appears on
blade server running
Microsoft Windows 2000.
Before switching ownership of the media tray to another blade server, safely stop the
media tray devices on the blade server that currently owns the media tray, as follows:
1. Double-click the Unplug or Eject Hardware icon in the Windows taskbar at the
bottom right of the screen.
2. Select USB Mass Storage Device, and click Stop.
3. Click Close.
You
can now safely switch ownership of the media tray to another blade server.
90 BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide