Filter
Top Products
1. Remove the bezel from the front of the BladeCenter T unit (see “Removing the
bezel assembly” on page 43 for instructions).
2. Place the bezel front-side down on a work surface.
3. Remove the air-filter retainer by pulling the retainer upwards and off the
ball-stud fasteners on the bezel.
4. Remove the old air filter from the bezel frame.
5. Remove the new air filter from its packaging.
LED window
LED holes
Ball-studs
Bezel
Ball-stud clips
LED pipes
Air-filter
Air-filter retainer
6. Align the LED window of the filter with the holes for the LEDs on the bezel and
lay the filter into the bezel frame.
7. Align the air-filter retainer over the filter with the ball-stud clips facing down and
the LED light pipe lined up with the LED holes on the bezel.
8. Gently push the air-filter retainer down until it snaps into the ball-stud fasteners
on the back of the bezel.
9. Install the bezel on the front of the system (see “Installing the bezel assembly”
on page 44 for instructions).
Chapter 4. Setting up the BladeCenter T hardware 45