Filter
Top Products
Setting up the remote connection
To configure and manage the BladeCenter T unit and blade servers, you must first
set up the remote connection through an Ethernet port on the LAN module. The
LAN module is on the rear of the BladeCenter T unit at the top-right side.
LAN module
KVM module
TOP
D
TOP
D
BTM
E
BTM
E
24
13
CRT
MJR
MNR
2
Alarms
1
Cabling the Ethernet port
You can connect to an Ethernet port directly from a personal computer (PC) using a
cross-over cable, or you can make the connection through an Ethernet switch.
The right Ethernet port on the LAN module is driven by management module 1, and
the left Ethernet port of the LAN module is driven by management module 2.
Connect directly to PC
Connect through an Ethernet switch
LAN module
TOP
D
TOP
D
BTM
E
BTM
E
Rear of BladeCenter T type 8730 unit
192.168.70.125
192.168.70.135
192.168.70.155
Ethernet switch
24
13
2
Alarms
1
RJ-45
connector
Cross-over
Ethernet cable
Standard
Ethernet
cables
Chapter 2. Configuring the BladeCenter T unit 25