Filter
Top Products
Preinstallation steps
Before you begin, read the documentation that comes with your module or option.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Complete the following steps before you install or remove a module or option in the
BladeCenter T unit.
Note: These instructions assume the BladeCenter T unit is connected to power.
1. Read the safety information beginning on page 113 and the guidelines in
“Handling static-sensitive devices” on page 40. This information will help you
work safely with your BladeCenter T unit and options.
2. If you are installing or removing a module at the front of the BladeCenter T unit,
complete the following steps:
a. Remove the bezel assembly from the front of the BladeCenter T unit. See
“Removing the bezel assembly” on page 43 for instructions.
b. Connect an ESD wrist strap to the ESD connector at the front of the
BladeCenter T unit (see the illustration on page 40 for the location of the
ESD connector).
3.
If you are installing or removing a module at the rear of the BladeCenter T unit,
connect an ESD wrist strap to the ESD connector at the rear of the BladeCenter
T unit (see the illustration on page 40 for the location of the ESD connector).
4. Go to the instructions for the module or option you wish to install.
42 BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide