Filter
Top Products
Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 51
3 Scan the SET bar code on page 51.
4 Scan the Set Suffix bar code.
5 Using the list of bar codes that starts on page 154, scan the
four digits corresponding to the hex values you chose in
Step 2.
For this example, you would scan 0, A, 0, and D.
6 Scan the END bar code.
You have added a two-character suffix to all bar code data,
regardless of label symbology, that will be added to the label data
before it is sent to the host.
Note: Successful programming requires four digits for the
label ID.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
Setting Global Suffix(es)
SET -------------------------------------------
Set Suffix ---------
Use the ASCII chart on page 158 to identify the ASCII character(s) and the
corresponding hex code(s) for the suffix. Then use the bar codes on page 154
to scan the four digits corresponding to the hex values.