Filter
Top Products
Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 63
6 Scan the END bar code.
Disabling a Symbology-Specific Label ID
To disable a symbology-specific label ID, you follow the steps in
the “
To set a single-character label ID” procedure on page 62,
except you must scan four zeros in Step 5.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.