Filter
Top Products
Site Electrical Wiring Guidelines
WARNING: Certain ports on the router are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE, Issue 4) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning surges and
commercial power disturbances, the intrabuilding ports must not be metallically
connected to interfaces that connect to the OSP or its wiring. The intrabuilding ports
on the router are suitable for connection to intrabuilding or unexposed wiring or
cabling only. The addition of primary protectors is not sufficient protection for
connecting these interfaces metallically to OSP wiring.
WARNING: DC-powered J2350, J4350, and J6350 Services Routers are intended for
installation only in a restricted access location.
When planning the electrical wiring at your site, consider the factors discussed in
the following sections.
Signaling Limitations
Improperly installed wires can emit radio interference. In addition, the potential for
damage from lightning strikes increases if wires exceed recommended distances, or
if wires pass between buildings. The electromagnetic pulse (EMP) caused by lightning
can damage unshielded conductors and destroy electronic devices. If your site has
previously experienced such problems, you might want to consult experts in electrical
surge suppression and shielding.
Radio Frequency Interference
You can reduce or eliminate the emission of radio frequency interference (RFI) from
your site wiring by using twisted-pair cable with a good distribution of grounding
conductors. If you must exceed the recommended distances, use a high-quality
twisted-pair cable with one ground conductor for each data signal when applicable.
Electromagnetic Compatibility
If your site is susceptible to problems with electromagnetic compatibility (EMC),
particularly from lightning or radio transmitters, you might want to seek expert
advice. Strong sources of electromagnetic interference (EMI) can destroy the signal
drivers and receivers in the router and conduct power surges over the lines into the
equipment, resulting in an electrical hazard. It is particularly important to provide a
properly grounded and shielded environment and to use electrical surge-suppression
devices.
108 ■ Power Guidelines, Requirements, and Specifications
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide