Juniper Networks J6350 Network Router User Manual


 
Figure 70: Connecting to the Console Port on J4350 and J6350 Routers
Connecting to the CLI Remotely
You can connect to the CLI from a remote location through two dial-up modems: a
modem that is connected to the console port on the Services Router and a second
modem connected to a remote management device. The modem connection allows
you to remotely perform the same console operations you can perform locally.
This section contains the following topics:
Configuring the Modem at the Router End on page 141
Connecting the Modem to the Console Port on page 142
Connecting to the CLI at the User End on page 143
Configuring the Modem at the Router End
NOTE: These instructions use Hayes-compatible modem commands to configure the
modem. If your modem is not Hayes-compatible, refer to the documentation for
your modem and enter equivalent modem commands.
Before you can connect a dial-up modem to the console port on the Services Router,
you must configure the modem to accept a call on the first ring and accept Data
Terminal Ready (DTR) signals. You must also disable flow control on the modem.
To configure the modem on the router end:
1. Connect the modem to a PC or laptop computer.
2. Power on the modem.
Connecting to a Services Router 141
Chapter 7: Establishing Basic Connectivity