Juniper Networks J6350 Network Router User Manual


 
Chapter 11
Troubleshooting Hardware Components
This chapter contains the following topics:
Chassis Alarm Conditions on page 209
Troubleshooting Power Management on page 210
Contacting the Juniper Networks Technical Assistance Center on page 212
Chassis Alarm Conditions
You can monitor alarms to troubleshoot hardware problems on a Services Router.
Alarms alert you to conditions on the router chassis, or in the system software that
might prevent the router from operating normally. You can monitor active alarms
from the J-Web interface or the CLI.
Services Router alarms warn you about conditions that can prevent the router from
operating normally. Chassis and system alarm conditions are preset. When the
Routing Engine detects an alarm condition, it lights the ALARM LED on the front
panel. When the condition is corrected, the light turns off.
To view a more detailed description of the alarm cause, issue the show chassis alarms
CLI command:
user@host> show chassis alarms
Table 70 on page 209 describes alarms that can occur for a chassis component such
as the Routing Engine or a Physical Interface Module (PIM).
Table 70: Chassis Alarm Conditions and Corrective Actions
Alarm SeverityCorrective ActionAlarm ConditionsComponent
Yellow (minor)Typically, the router boots from the
internal compact flash. If you
configured your router to boot from
an alternative boot device, ignore this
alarm condition.
If you did not configure the router to
boot from an alternative boot device,
contact JTAC. (See Requesting
Technical Support on page xxi.)
The Services Router boots from
an alternative boot device.
Alternative boot media
Chassis Alarm Conditions 209