Filter
Top Products
Chapter 3—Operation
3-22 Hughes-JVC Technology Corporation
3.13. PC or VT-100 Terminal Control
The projector can be controlled by a VT-100 terminal. If a VT-100 is not available,
a PC with W
INDOWS
3.1 or P
RO
C
OMM
for
DOS can emulate a VT-100. Table 3.0-
10 on page 3-23 shows the equivalent commands for the terminal and both
remotes.
To control the projector by a PC or VT-100 Terminal:
1. From W
INDOWS
P
ROGRAM
M
ANAGER
, select T
ERMINAL
, then S
ETTINGS
.
2. Select T
ERMINAL
E
MULATION
from S
ETTINGS
MENU
.
3. Select DEC VT-100(ANSI) (may already be selected).
4. Use a Null Modem cable to connect between the projector and the terminal.
5. Refer to Section 3.13.1Terminal Preferences and 3.13.2 Communications
Protocol for W
INDOWS
setup.
3.13.1. Terminal Preferences
Select S
ETTINGS
again from the menu bar. Select T
ERMINAL
P
REFERENCES
. Set the modes as indicated in Table 3.0-8 below.
Table 3.0-8 Terminal Preferences
Modes Modes
Line Wrap
Yes
CR#
##
#CR/LF
Local Echo
No
Inbound
No
Sound
Yes
Outbound
No
Columns Cursor
80
Yes
Block
Yes
132
No
Underline
No
Terminal Font Blink
Yes
Courier 12
Translations
NONE
Terminal Show IBM to ANSI
No
Scroll Bars
Yes
Buffer Lines
100
Use Function Arrow and Control keys for Windows
No