Filter
Top Products
Chapter 4—Setup Adjustments
4-46 Hughes-JVC Technology Corporation
Table 4.0-9 Terminal Preference Selections
Terminal Preferences
Terminal Modes
= Sound
CR#
##
#CR/LF
=OFF
Columns
=80
Cursor
= Block and Blink
Terminal Font
= Fixedsys 15
Translation
=none
Show Scroll Bars
=ON
Buffer Lines
=100
Use Function Arrow
and Control keys for Windows = OFF
Select OK.
7. Under Settings select Text Transfer = Standard Flow Control. Select OK.
8. Under Settings select Communications and choose.
Table 4.0-10 Terminal Preference Selections
Connector
= PC port being used
Baud Rate
=
9600 or 19200 ∇
Data Bits
=8
Stop Bits
=1
Parity
= none
Parity Check
=OFF
Carrier Detect
=OFF
Flow Control
= XON/SOFF
∇
Depends on the System Controller Switch Block:
Pos 4 ON = 9600 Pos 4 OFF = 19200
Select OK.
9. Press C
TRL
+ S
HIFT
+_ to reboot the B
OOT
M
ANAGER
.
The Power On LED stays Red.
NOTE: The switch block at SW1 of the System Controller Board
controls the baud rate for Serial Port A for the Boot Manager and System
Software. This switch is factory-set ON for switch positions 1-4.
If new software will not load correctly and it becomes necessary to check
this switch, contact HJT Field Service.
10. The following should be displayed on the W
INDOWS
T
ERMINAL
screen
(where x.x.0 is the currently loaded Boot Manager version [e.g. 1.3.0]).