Filter
Top Products
1-8 A-61092 September 1999
Operating keys and indicators
Key/Indicator Function
Clear/Cancel The C key allows you to:
• Cancel a function without changing the preset values.
• Clear the status display after executing specified function codes.
• Clear an operator message from the status display.
Run Turns on the feeder and transport system.
NEXT Allows you to enter the next document image address.
Stop Allows you to stop the feeder and transport system. Documents still in the transport
system will be scanned and placed in the exit hopper before the transport system
stops.
Enter Enters data for a function code or an image address change.
Confirmation tone/alarm
The confirmation tone/alarm is located under the control panel and
sounds when one of the following conditions occur:
• Run is pressed (one long tone).
• Stop or End is pressed (many short tones followed by a long tone).
• Feeder clutch engages/disengages (one short tone).
• Incorrect key is pressed (three short tones).
• Document skew is greater than what is setup in the skew
parameter, or when a document is shorter or longer than the
specified length parameters (one short tone).
• A bar code is detected (if the accessory is enabled and the
confirmation tone is enabled).
• A patch code is detected (if the accessory is enabled and the
confirmation tone is enabled).
• The Footswitch is detected (if the accessory is enabled and the
confirmation tone is enabled — one short tone).